Volvo XC60: Laminated panoramic roof

Introduction

The laminated panoramic roof is divided into two sections.

• The rear glass section is fixed in place and cannot be moved.

• The front glass section can be slid horizontally to the open or closed positions or its rear edge can be raised and lowered to allow ventilation.

All references in this section to opening or closing the panoramic roof pertain to the front glass section.

The laminated panoramic roof also has a sun shade made of perforated fabric that is located below the sections of glass. This shade can be opened or closed, for example when driving in bright sunlight.

Both the laminated panoramic roof and the sun shade are operated by the controls in the ceiling console, near the rear-view mirror. The vehicle's ignition must be in mode I or II before the laminated panoramic roof/sun shade can be operated.

CAUTION • Remove ice and snow before opening the laminated panoramic roof.

• Never place heavy objects on the laminated panoramic roof.

Operation

1 Auto open (arrow points toward the rear of the vehicle)
2 Manual open
3 Manual close
4 Auto close

WARNING
• During manual closing, if the laminated panoramic roof is obstructed, immediately open it again.
• Never open or close the laminated panoramic roof if it is obstructed in any way.
• Never allow a child to operate the laminated panoramic roof.
• Never leave a child alone in a vehicle.
• Never extend any object or body part though the open laminated panoramic roof, even if the vehicle's ignition is completely switched off.

Automatic operation

1. To open the sun shade completely, pull the control as far back as possible (to the auto open position) and release it.

2. To fully open the laminated panoramic roof, pull the control as far back as possible a second time (to the auto open position) and release it.

Quick open/close

The laminated panoramic roof and the sun shade can be opened/closed at the same time:

• Open - pull the control back (to the auto open position) twice in quick succession and release it.

• Close - push the control forward (to the auto close position) twice in quick succession and release it.

Manual operation

1. Opening the sun shade: Pull the control back to the first stop (the manual open position) and hold it until the sun shade has opened to the position of your choice.

2. Opening the rear edge of the laminated panoramic roof: Pull the control back to the first stop (the manual open position) a second time to open the rear edge of the laminated panoramic roof.

3. Opening the front glass section: Pull the control back to the first stop (the manual open position) a third time and hold it until the laminated panoramic roof has opened to the position of your choice.

Perform this procedure in reverse order to close the laminated panoramic roof and/or sun shade.

NOTE
For manual opening, the sun shade must first be fully open before it will be possible to open the laminated panoramic roof.
When closing, the laminated panoramic roof must be fully closed before the sun shade can be closed.

Tilt position

Tilt position, raised at the rear edge

1 Open (raise the rear edge of the front glass section) by pressing the rear edge of the control upward.

2 Close by pulling the rear edge of the control downward and holding it until the laminated panoramic roof has closed completely.

If the sun shade is completely closed, it will open approximately 2 inches (5 cm) when the laminated panoramic roof is opened to the tilt position.

Wind blocker

Wind blocker

The moonroof is equipped with a wind blocker that folds up when the moonroof is open.

Compass

HomeLink® Wireless Control System